Fingerboard Trucks Design Fingerboard Trucks 34mm 36mm for Finger Skateboard for Skateboard Wooden Deck Par(34mm Purple)

General Installation and Setup Tip: Before mounting, verify that mounting screws match both truck baseplate holes and board thread specifications. Apply firm, even pressure when threading to prevent cross-threading. After installation, check wheel spin and adjust axle nuts for minimal side-to-side play while allowing free rotation. Periodically inspect kingpin nut tightness and adjust bushing compression to personal preference.Material:Zinc alloySize:36mm/34mm/32mmKingpin:Normal kingpinNote:1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.2. Please allow slight manual measurement deviation for the data.

• Upgraded Baseplate Design: The baseplate geometry provides a stable foundation for the truck assembly, distributing forces evenly during tricks and reducing stress concentrations that could lead to component fatigue over time
• Inverted Kingpin Configuration: The recessed kingpin design positions the pivot point lower within the hanger, allowing smoother turning response while keeping the fastener protected from impact during rail slides and hard landings
• Knurled Axle Retention System: Precision-textured axle surfaces grip the hanger material securely, preventing rotational loosening during use and maintaining consistent wheel alignment through repeated trick execution
• Electroplated Corrosion-Resistant Finish: The protective metal coating creates a durable surface layer that resists oxidation and wear from handling, maintaining the component appearance through extended practice sessions
• High-Strength Alloy Construction: Each truck component is cast from solid alloy that provides rigidity under load while keeping overall weight low, optimizing the balance between durability and responsive feel